Yep, the screenshot above refers to HP ProCurve 2920 Switch Series Installation and Getting Started Guide (2013), the screenshot below came from the HP 2920 Switch Series Stacking Technical Whitepaper (2015)I think there isn't a real difference about Stacking Cables placing between those two different ways (remember both are used to create a Chain Topology Stack). The 2920 delivers a consistent wired/wireless user experience with advanced security and network management tools with Aruba ClearPass Policy Manager and Aruba AirWave. With support from Aruba Central, you can quickly set up remote branch sites with little or no IT support. The Aruba 2920 Switch Series provides cost-effective pay as can communicate on your network, or if you are not using VLANs, HP recommends that you use the Switch Setup screen to quickly configure IP addressing. To do so, do one of the following: Enter setup at the CLI Manager level prompt. HP4108# setup Select 8. Run Setup in the Main Menu of the menu interface. For more on using the Switch Setup screen Hi, Do you want to reset the switch to factory default configuration if yes then pelase follow below steps on last row:. or you can refer below link for HP 2920 Switches Installation and Getting Started Guide The HP 2920 Switches Installation and Getting Started Guide explains on page 2-24 the serial port connection settings. My Zterm connected instantly without any changes from the default, but here are the settings you need to use: Any Baud Rate between 1200 and 115200; 8 data bits; 1 stop bit statements of which you should be aware when installing and using a Routing Switch. • HP ProCurve Installation and Getting Started Guide - an electronic (PDF) guide containing product safety and EMC regulatory statements as well as installation and basic configuration information. This guide is View and Download HP ProCurve 2650 install manual online. HP ProCurve 2650: Install Guide. ProCurve 2650 switch pdf manual download. Table of Contents: Introducing The Hp Procurve Switch 2650 - Page 9; Front Of The Switch - Page 10; Leds - Page 11; Port Led View Select Button And To use: connect an RJ-45 network cable to the Management port to manage an HP 5400R zl2 Switch through Telnet from a remote PC or a UNIX workstation. To use this port, the switch must have an IP address. IP settings can be configured through a Console port connection or automatically from a DHCP/ Bootp server. Configuration Manual, Installation And Configuration Manual, Installation And Getting Started Manual, User Manual, Security Manual, Installation Manual, Quick Start Manual, Manual Supplement, Read Me First, Specification Sheet, Quick Setup Manual QuickSpecs HP 2920 Switch Series Overview c04111401 — DA - 14499 Worldwide — Version 14 Getting Started With Switch Configuration This chapter is a guide for using the console Switch Setup screen to quickly assign an IP (Internet Protocol) address and subnet mask to the switch, set a Manager password, and, optionally, configure other basic features. For more information on using the switch console and the other switch