Hide Search. Pipe Fitting Installation Instructions. 101 - UCC - Single Band - Std Range. 102 - UCC - Multi Band - Ext Range. 103 - Tapped Universal Clamp - Std Range. 104 - Tapped Universal Clamp - Extended Range. 105 - Collar Leak Clamp. 106 - Bell Joint Leak Clamp PVC. 108 - UCC - Sewer Clamp. FACTORY-BUILT INSULATED CHIMNEY Installer: It is of the utmost importance that these instructions are left with the homeowner. Homeowner: Keep these instructions and maintenance guide in a safe place for future reference. INSTALLATION I NSTRUCTIONS & MAINTENANCE G UIDE Tested to Standard CAN/ULC-S629 & UL 103 Type HT PLEASE READ ALL Technical Data Kingflex Technical Data Property Unit Value Test Method Temperature range °C (-50 - 110) GB/T 17794-1999 Density range Kg/m3 45-65Kg/m3 ASTM D1667 Water vapor permeability Kg/(m.s.pa) ≤0.91×10 ﹣¹³ DIN 52 615 For bottom end punch, bottom and middle screw closed and top opened 1/16th. Your temps will come up some and you can check the sizzle like the factory pipe instructions state. You may go through a few more couplers but the gain to me was worth the 20 bucks at the end of the summer. For top end, the top screw 1/16th and the bottom 1/16-1/8. Factory Pipe Instructions Yamaha GP1200R Disconnect the battery and remove the power valve servo and cables with the bracket. Completely remove the stock exhaust/catalytic converter system from the cylinder to the water box and leave the stock 3/8" waterlines attached to the side squirters. Remove the two studs on the center cylinder. "Factory Pipe Instructions 701 SuperJet Limited & Mod Remove the stock exhaust system. If you are going to replace your stock waterbox do so now, if not, do not remove it. Factory Pipe offers a waterbox to compliment this system. Remove the battery, battery box and the empty fuel tank. This is THE pipe for the freestyle and surf rider looking for the best bottom end grunt for their SXR. Unreal performance and fit. Easy install and tuning. ( Click here for installation Instructions) Part Number: 01-01-007. PLEASE NOTE: This product has been discontinued. The information contained on this page is for reference use only. Factory Pipe - Yamaha Superjet B-Pipe Exhaust Kit PN# 01-01-054 - Yamaha B-Pipe MOD Kit (Instructions) * LIMITED (Instructions) * MOD (Instructions) * Suggested Jetting - Are for 730 feet above sea level on a stock engine with aftermarket flame arrestors. Your specific adjustments may vary depending on engine modifications, fuel, altitude Factory Pipe Instructions 750SX/SXi Limited Note: 1. For installation on the SXi you will need to remove the left rear ventilation tube and air box from the inside of your hood. This is a legal modification for limited class racing. 2. Aftermarket flame arrestors (K&N, Vortex) are recommended, or rotate the Introduction to Piping Fabrication (with PDF) Pipe fabrication can be defined as the process of cutting, bevelling, and welding piping components such as pipes, tees, elbows, flanges, reducers, etc., as dictated by the design documents. In the process and power piping industry, Piping fabrication is a highly critical activity as it involves of the pipe. • Do not force the tool into the pipe. • Improper lubrication (too much or too little) on the expansion cone and head may result in faulty connections which could result in leaking and property damage. • Always remove the battery pack before changing or removing accessories, and only use accessories specific